Go to INNOVA Blogs RSS

The fleece-finished reverse side makes handling in the printing machine easier Foam substructures with fleece finishing correspond to the latest developments in the prepress of corrugated cardboard direct printing. The fleece on the back makes it easier for the printer to position the post-print assembly on the printing cylinder. Smufit Kappa Neuburg tested the handling and printing properties of a new fleece substructure together with the prepress company Horst Gries. Pressure-absorbing foams made from closed-cell polyethylene, more precisely from HDPE, have long proven themselves in direct printing on corrugated cardboard. As a compressible base, they allow the use of thinner and harder photopolymer...

Read more

Cushion backing foams Better handling of the printing plate in corrugated cardboard postprint Groundbreaking for the still young company Innova Flexo Products GmbH was the customer’s request to further improve a proven product in corrugated post-printing. Based on many years of expertise and a brilliant idea, the development of a substructure with simple positioning behavior on the printing cylinder succeeded. Pressure-absorbing flexo cushion backing foams have long proven themselves in direct printing on corrugated board. As a compressible base, they allow the use of thinner, harder photopolymer plates. In the printing press, they reduce the contact pressure on the printing...

Read more

Dieter Finna Groundbreaking for the still young company Innova Flexo Products GmbH was the customer's request to further improve a proven product in corrugated post-printing. Based on many years of expertise and a brilliant idea, the development of a substructure with simple positioning behavior on the printing cylinder succeeded. Pressure-absorbing foams have long proven themselves in direct printing on corrugated board. As a compressible base, they allow the use of thinner, harder photopolymer plates. In the printing press, they reduce the contact pressure on the printing plate in the printing nip and thus enable a lower dot gain, finer screen...

Read more

No matter if you mount a few cylinders on your label press or up to 100 wide web sleeves a day. The mounting always has an impact on the print result. When preparing your sleeves and plates for the mounting there are just a few key factors. If you get them right, it will save a lot of trouble later on. Here we will look on the preparation of the sleeve before mounting the tape. A general guide into plate mounting preparation.

Read more

When it comes to mounting jobs with greater goals, INNOVALUX gives you that little extra in performance. This customer is using Kodak plates on a Flatmount machine. With our cushion backing foam - INNOVALUX 1.7 prelaminated on 0.3mm Mylar nothing much can go wrong. Instead you get perfect positioning and stability due to the smooth non-vowen surface of from this special cushion mounting material.     click here for original post and video:https://www.linkedin.com/posts/ugcPost-6754121566793019392-RrUh in cooperation with oneflexo.comfor more info Iín INNOVALUX cushion backing click here

Read more

[id*='section'] .rte video{ margin: 0 auto !important; display: block !important; margin-bottom: 30px !important; }